diff options
| -rw-r--r-- | case/top.scad | 24 |
1 files changed, 12 insertions, 12 deletions
diff --git a/case/top.scad b/case/top.scad index 3fcbd6a..44f4ba1 100644 --- a/case/top.scad +++ b/case/top.scad @@ -107,8 +107,8 @@ module top_case(key_switch_sizes, pcb_screw_holes) { ]; for (post = posts) { - translate([post[0], post[1], wall_height - wall_width - post[2]]) - screw_post(post[2]); + translate([post[0], post[1], wall_height - wall_width - post[2] - eps]) + screw_post(post[2] + eps); } } @@ -196,22 +196,22 @@ module top_case(key_switch_sizes, pcb_screw_holes) { for (x = [0: support_x_interval: keyboard_width + 2 * wall_width]) { translate([support_x_offset + x, - upper_support_y_offset, + upper_support_y_offset - eps, wall_height - wall_width]) - support([upper_support_length, keyboard_switch_height], support_width); + support([upper_support_length + 2*eps, keyboard_switch_height], support_width); translate([support_x_offset + x, - lower_support_y_offset, + lower_support_y_offset - eps, wall_height - wall_width]) - support([lower_support_length, keyboard_switch_height], support_width); + support([lower_support_length + 2*eps, keyboard_switch_height], support_width); } for (y = [0: support_y_interval: keyboard_length + 2 * wall_width]) { - translate([right_support_x_offset, + translate([right_support_x_offset - eps, support_y_offset + y - wall_width + support_width, wall_height - wall_width]) rotate([0, 0, -90]) - support([right_support_length, keyboard_switch_height], support_width); + support([right_support_length + 2*eps, keyboard_switch_height], support_width); translate([left_support_x_offset - eps, support_y_offset + y - wall_width + support_width, @@ -227,17 +227,17 @@ module top_case(key_switch_sizes, pcb_screw_holes) { /* Upper */ translate([0, case_length_bottom - wall_width, 0]) - cube([case_width_bottom, wall_width, wall_height - wall_width], false); + cube([case_width_bottom, wall_width, wall_height], false); /* Right */ translate([case_width_bottom - wall_width, 0, 0]) - cube([wall_width, case_length_bottom, wall_height - wall_width], false); + cube([wall_width, case_length_bottom, wall_height], false); /* Lower */ - cube([case_width_bottom, wall_width, wall_height - wall_width], false); + cube([case_width_bottom, wall_width, wall_height], false); /* Left */ - cube([wall_width, case_length_bottom, wall_height - wall_width], false); + cube([wall_width, case_length_bottom, wall_height], false); } module screw_holes() { |