From d5b4b6c541184cfb0bdef19f8d6438807499fd16 Mon Sep 17 00:00:00 2001
From: XANTRONIX Development
Date: Fri, 17 Nov 2023 10:06:00 -0500
Subject: Yes, I might design a bottom case, too

---
 case/top.scad | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

(limited to 'case')

diff --git a/case/top.scad b/case/top.scad
index 7b84ccd..1455255 100644
--- a/case/top.scad
+++ b/case/top.scad
@@ -23,7 +23,7 @@ screw_post_middle_y_offset = 72.50;
 screw_post_lower_y_offset  = (keyboard_y_offset - 2 * wall_width) / 2 + wall_width;
 screw_post_x_offset        = (keyboard_x_offset - 2 * wall_width) / 2 + wall_width;
 
-case_screw_posts = [
+top_case_screw_posts = [
     /* Upper row */
     [screw_post_x_offset,   screw_post_upper_y_offset, screw_post_corner_height],
     [case_width_bottom / 2, case_length_bottom - 10.0, screw_post_middle_height],
@@ -104,7 +104,7 @@ module top_case(key_switch_sizes, pcb_screw_holes) {
         }
 
 
-        for (post = case_screw_posts) {
+        for (post = top_case_screw_posts) {
             translate([post[0], post[1], wall_height - wall_width - post[2] - eps])
             screw_post(post[2] + eps);
         }
-- 
cgit v1.2.3